Wanting to know what others are using for exterior stair risers? Have a couple of sets of stairs to replace steps and risers. Traditionally used are fir for both. I have considered using some sort of composite for the steps but believe the stringers are too far apart-close to 36 inches for both sets. Risers I have
I was always taught and still use 2x8s for the kick board (riser) when I build stairs. I see quite a few If you use 2x material you cut off that amount from the top back side of the stringer if you use 1x material then you cut that amount off. .. We build the exterior step and decks with the rest of the house.
There are lots of viable methods that avoid the pitfalls that lead to uneven risers, tilted staircases, and downright collapses; in this article, I describe my practices materials for a landing, consider these benefits - a level surface for a precise total rise measurement and a stable footing to rest the staircase on.
Stair risers may not have openings present that would allow a 4” diameter sphere to pass through. Most risers are made from deck boards or fascia material. Make sure the material is heavy duty enough to resist feet kicking the risers. If you are using 1x material you may want to install blocking behind the riser board for
Buy three treated 2x10s, two 2×12 skirts and two 2x4s sized to the next larger length and you'll have plenty of material to work with (the worst mistake is buying material that's too short!). Get a 6-ft. 2×6 for securing the stairs to the deck (Photo 8). You'll also need two 2x6s for each tread and a 1×8 for each riser. Use 3-in. deck
Every stair-framing project has its own unique circumstances that always have to be considered—from simple to complex, interior to exterior, winders, landings, radius, type of finish materials, railings, etc. However, there are some consistent factors in framing stair stringers that are almost always the same.
Shop deck stair stringers in the deck stairs section of Lowes.com. Find quality deck stair stringers online or in store.